Stainless steel door frame forming machine
1. Molding process
Automatic feeding-guidance-leveling, feeding-continuous punching-forming-fixed length, cutting-receiving
2. Unit performance
2.1 Range of rolled plates
Material: galvanized sheet, low carbon steel, such as Q235
Sheet thickness: 0.8≤∮≤1.5㎜
Sheet width: 150≤§≤300㎜
2.2 Production area: 30 meters long X 3 meters wide
2.3 Total installed capacity: 42kw
2.4 Equipped with air source: air source: 0.9 cubic meters per minute, 0.6~0.7MPa
3. Technical parameters of main components
3. 1 Automatic feeding machine:
3.1.1 Internal expansion type, 3T load
3.1.2 Drive 4kw variable frequency motor
3.1.3 Inner diameter of coil: ￠500~￠520mm, outer diameter of coil: ≤1200
3.1.4 Electrical induction automatically controls the discharge speed
3. 2 guide frame:
3.2.1 A pair of horizontal rollers, two opposite rollers
3.2.2 It has the function of moving in the same direction and guiding movement
3. 3 leveling machine
3.3.1 Correction rollers: upper 4 / lower 4, a pair of pinch rollers front and rear.
3.3.2 Range of leveling ring material: material width≤350mm, material thickness≤0.8-1.5mm
3.3.3 Driving force: 2kw servo motor
3, 4 continuous punching part
3, 4, 1 frame: four-post punching frame
3.4.2 Die: die; die material: Cr12, quenched, hardness reaches 58-62°
3. 5 forming host
3, 5, 1 frame: the frame is gantry type, side pull type to replace the rollers.
3, 5, 2 forming frame: 18 frames
3, 5, 3 The maximum feeding width ≤ 350 mm, the thickness of the rolled plate: 0.8 ≤ ∮ ≤ 1.5 ㎜
3, 5, 4 roll shaft diameter: ￠60mm, material 40Cr, heat treatment: quenched and tempered
3, 5, 5 roller material: GCr15, overall quenching treatment, hardness HRC56-62o
3, 5, 6 motor power: 22kw frequency conversion motor, ZQ400 type reducer
3, 5, 7 transmission mode: each frame is equipped with a gear distribution box transmission (except for the main power position)
3.6 Cut off part
3, 6, 1 hydraulic blade cutting
3, 6, 2 hydraulic pump station: 5.5kw
3, 6, 3 blade material: Cr12, quenching treatment.
3. 7 electrical control: PLC control, LCD screen operation, fixed length encoder.
The door and window forming unit has various models and various types, which are widely used in the production of rolling shutters, door frames, guide rails, window frames, and window rails in the door and window industry.
Types of models mainly include fire-resistant single-layer and double-layer rolling door rolling gates, door frame machines (ordinary door frame machines, curved door frame machines, KFC door frame machines, etc.), 65 rail machines and guide slot machines, Australian rolling shutters and European rolling shutters Machine, window frame machine, window rail machine and door panel production line, fully automatic door frame production line, etc.
The full-automatic door frame production line is controlled by a PLC machine, and the whole set of door frames can be produced by stamping and forming at one time.