Solar photovoltaic bracket production machinery is a cold-formed equipment for producing solar panel support frames. The equipment can be manually adjusted or replaced by several sets of rollers to complete the production requirements of different specifications of brackets. Solar photovoltaic brackets are used in solar photovoltaic power generation systems for placement and installation. , Special bracket designed to fix solar panels.
The production process of photovoltaic support molding equipment is as follows:
Unwinding and unwinding-feeding guide platform-leveling and straightening-servo feeding-online punching-roll forming (including gear hobbing, shaping)-tracking and cutting-receiving, including hydraulic control system, The electric control box control system and other parts have the characteristics of reasonable structure, simple operation, safe and reliable, short production process, and wide product use.
Device parameters:
●Rack: the rack is gantry type
●Forming frame: 16-20 frames
●Feeding width≤250㎜
●Roll shaft diameter: ¢80mm, material 40Cr, heat treatment: quenched and tempered
●Roller material: GCr15, overall quenching treatment, hardness HRC56-62º
●Motor power: 22kw variable frequency motor, ZQ500 reducer
● Transmission mode: each rack is equipped with a gear distribution box transmission (except for the main power position)
Punching method: automatic online punching by the punch (optional)
Introduction of solar photovoltaic support production equipment
Equipment technical requirements
2.1 Equipment technical conditions:
2.1.1 Equipment area: 25×3.5×5 (length×width×height) meters.
2.1.2 Equipment feeding direction: To be determined.
2.1.3 Voltage parameters 380, 50Hz, 3 phases.
2.1.4 Air source: flow rate is 0.5m3/min; pressure is 0.6MPa.
2.1.5 Hydraulic oil: 46# hydraulic oil.
2.1.6 Gear oil: 18# hyperbolic gear oil.
2.2 Main technical parameters of the equipment
2.2.1 Rolling strip width: ≤200 mm
2.2.2 Rolling strip thickness: 2.0~2.5 mm
2.2.3 Rolled steel strip material: low carbon steel, etc.
2.2.4 Production speed: the punching speed of the whole line is about 9 m/min
2.2.5 Length of rolled workpiece: 2000—6000 mm
2.2.6 Total installed capacity of equipment: about 38.5KW.
3. Range of rolled products
3.1 This stamping/forming unit can roll C-shaped materials with a thickness of 2.0~2.5mm.
3.2 Specifications and dimensions of rolled products
Can be designed and produced according to customer drawings or samples